Kataloog
Laeb...
Voolukaablid pedaalidele, voolualalditele ning võimenditele.
CIOKS Parallel adapter Flex – 10cm / 4″ (sand grey). By using two isolated outlets the Parallel adapter Flex gives you the sum of max. currents of the two isolated outlets used. This adapter cable should be used in combination with any of CIOKS standard Flex cables if you need to power pedals with higher current needs. It gives you not only the higher...
CIOKS Flex 1 – 30cm (12″) with 5,5/2,1mm centre negative angled DC plug (black)
CIOKS Flex 1 – 15cm (6″) with 5,5/2,1mm centre negative angled DC plug (black)
CIOKS Flex 1 – 50cm (20″) with 5,5/2,1mm centre negative angled DC plug (black)
Type 3 Flex kaabel on kollane ja keskelt negatiivse polaarsusega 5,5/2,5mm DC pistikuga. See kaabel sobib kui tahad toita Line6 Stomp seeria pedaali CIOKS DC7 voolualaldist.
The RockBoard Flat Power Cables are high-quality power supply cables for effects pedals and were developed, based on our Flat Patch Cables.
RockBoard Flat Daisy Chain voolukaablid on kvaliteetsed voolualaldi kaablid efektipedaalidele, mille aluseks on nende lameda peaga patch-kaablid. Nende äärmiselt kompaktsed pistikud on ühed kõige väiksemad kogu turul. Selle abil on võimalik kokku hoida väärtuslikku ruumi pedalboard-il
CIOKS 3-way daisy chain Flex – three 5,5/2,1mm centre negative DC plugs, 50+30+30cm / 20″+12″+12″ (black)
CIOKS Split Flex – two 5,5/2,1mm centre negative DC plugs, 30 & 50cm / 12″ & 20″ (black)
High-quality power supply cables for effects pedals and were developed, based on our Flat Patch Cables. Their super compact plugs are smaller than those of most other power cables on the market. This way they save valuable pedal board space. Other than most commonly available power cables, Rockboard Flat Power Cables do not use two parallel cable lines,...
The RockBoard Flat Power Cables are high-quality power supply cables for effects pedals and were developed, based on our Flat Patch Cables.
Kate daisy-chain kaablitele Sobib 2,1 x 5,5 mm pistikutele Hind tüki kohta!
Type 1 Flex cables are black and fitted with a centre negative 5,5/2,1mm DC plug. 80cm cable length.
Extension Flex is a 50cm cable with two RCA plugs, a male one in one end and a female at the other. You can use this Flex cable to make any other Flex cable 50cm longer.
This split adapter Flex makes it possible to power two pedals using only one outlet of the power supply but where the cable length and plug type can be chosen individually for each pedal. CIOKS Split adapter Flex – 10cm / 4″ (black)
Have a pedal that requires 18V or 24V? Connect our voltage doubler cable to Zuma or Ojai and provide more juice for your pedals with higher voltage requirements. Power supply connectors: 2.1mm straight (2). Pedal connector: 2.1mm female. Polarity: standard (center negative). Length: 4″ (10cm)
DC Power Cable with 20 cm / 7.87" length between each connector, black.
RockBoard Flat Daisy Chain voolukaablid on kvaliteetsed voolualaldi kaablid efektipedaalidele, mille aluseks on nende lameda peaga patch-kaablid. Nende äärmiselt kompaktsed pistikud on ühed kõige väiksemad kogu turul. Selle abil on võimalik kokku hoida väärtuslikku ruumi pedalboard-il
Connect two pedals to one power supply output, without hum or noise. Voltage stays the same, but amperes are divided for two pedals according their current draw. This cable enables you to get more out from your power supply.
Some pedals use higher voltage than normal 9 volts. With this cable you can combine two outputs from your power supply. This way you can double the voltage to suit pedal requirements. Combine two 9 volt outputs for 18 volts, Combine two 12 volt outputs for 24 volts, 2,1 mm adapter, Normal polarity, center negative.
A battery snap works with any effect that runs on 9V battery including vintage pedals without power jacks.
A cable with a 2.1mm right angle barrel and a 3.5mm right angle mini plug with standard (tip positive) polarity. The 3.5mm mini plug cable connection is compatible with older/vintage MXR, DOD, Electro-Harmonix, Pro-Co (Rat series), Klon Centaur, and vintage (non-LED) Voodoo Lab pedals.
Standard 2.1mm DC effects pedal power cables can be used with Zuma or Ojai to power most effects pedals available. Connector #1: 2.1mm straight. Connector #2: 2.1mm right angle. Polarity: standard (center negative). Quantity: 5 pack. Available in 18″ (46cm) and 36″ (92cm) lengths. Choose length before adding to cart.
Have a pedal that requires center positive polarity? Connect our 2.1mm reverse polarity cable to Zuma or Ojai and power your inverted-polarity pedals. Connector #1: 2.1mm straight Connector #1: 2.1mm female. Polarity: reverse (center positive). Length: 6″ (15cm)